J26 link arm width and implement capatibility - Page 2
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Junior Member
    Join Date
    Dec 2018
    Location
    Delaware, Ohio
    Posts
    24
    Thanks
    1
    Thanked 17 Times in 8 Posts
    Any update on this? Will the agrisupply scoop work on a CASE 44x 3 point?

  2. Remove Advertisements
    CaseColtIngersoll.com
    Advertisements
     

  3. #12
    Senior Member dave1mn2's Avatar
    Join Date
    May 2015
    Location
    St. Louis
    Posts
    3,414
    Thanks
    2,355
    Thanked 1,905 Times in 1,070 Posts
    Quote Originally Posted by ukewarrior View Post
    Any update on this? Will the agrisupply scoop work on a CASE 44x 3 point?
    Don't know the detailed differences between the various 3pts (I have an HH34) but I bought that scoop and have used it a fair amount. Soil, both from a pile and a cut, rock, mulch and snow, from a pile.

    Nov. 22 2016 029.jpg

    snow 032.jpg
    Its on the big side and takes a bit of time to adjust, depending on the job.

    If working from a pile, you can adjust it so that it will load and dump fully but if actually digging, it won't cut and lift high enough to fully dump. Still beats a shovel and a wheelbarrow, by a long ways. I bought extra long cat 0 pins and mounted them pointing inwards.

    It will technically fit faced forward but even more careful adjustment and rounding the cutting edge corners to avoid rear tire damage is needed.

    It would be better if it was some smaller but its the smallest I've found and have no regrets.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •