Kohler K321 crank seal replacement - Page 2
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Senior Member Dan444's Avatar
    Join Date
    Jun 2014
    Location
    NY USA
    Posts
    142
    Thanks
    9
    Thanked 25 Times in 15 Posts
    Thanks Gordy. Mine is much shorter. Maybe due to mine being k321? I hope so anyway.

  2. Remove Advertisements
    CaseColtIngersoll.com
    Advertisements
     

  3. #12
    Senior Member Gordy's Avatar
    Join Date
    Apr 2011
    Location
    Maple Lake, MN
    Posts
    2,091
    Thanks
    2,721
    Thanked 1,191 Times in 755 Posts
    Quote Originally Posted by Dan444 View Post
    Thanks Gordy. Mine is much shorter. Maybe due to mine being k321? I hope so anyway.
    A while back there was mention that the 12 Hp and 14 Hp are the same block, just the bore is bigger on the 14. And that you could have a 12 bored out to 14 Hp, then a few things to do for balancing. So it should be the same dipstick.

    Something for you to check. I measured the outside of the block from the bottom at the motor mount up to the flat the dipstick seats on, and got 9-1/2".


    Gordy

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •